Rockford Fosgate Punch PLC2 Punch Remote Level Control

Description

Product highlights
wired remote level control and clip light
works with the following 2013-up Rockford Fosgate Punch amplifiers:
P300X1, P400X1, P500X1bd, and P1000X1bd mono amps
P300X2, P400X2, P500X2, and P1000X2 2-channel amps
P600X4 4-channel amp
P1000X5 5-channel amp
18' remote cable and mounting hardware included
dimensions: 1-7/16"W x 1-1/4"H x 1-5/8"D (2-5/8"D with knob and cable)
warranty: 1 year
What's in the box
Rockford Fosgate Punch Level Control remote module
18' remote cable with RJ-45 connectors on each end
Mounting bracket
Two 1/2" Mounting screws
LED with attached 8" harness (used when mounting knob without its housing)
Additional front panel
Flat washer
Nut
Installation instructions
About this item
Written by Crutchfield's Buck Pomerantz
Control and monitor your amp's signal from the front seat
Rockford Fosgate's PLC2 wired remote allows you to control the volume of your Punch amp that's equipped with the C.L.E.A.N. (Calibrated Level Eliminates Audible Noise) setup system. From the driver's seat, you'll be able to adjust the amp's output level
and
monitor its incoming signal for distortion.
After using C.L.E.A.N. technology to set your amp's gain, just keep an eye on the PLC2's light. It'll turn red when the musical source is distorting, warning you to turn the receiver's volume down before your speakers or subwoofer suffer any damage.